<%@LANGUAGE="VBSCRIPT" CODEPAGE="65001"%> Means to Solve the Ball Mill Tile Oil Leakage Problem -- Mining machinery manufacturers Vipeak
 
Home         About us         News         Product          International Trade         Honors          After-Sales Service         Contact Us

 

Welcome to Zhengzhou Mining machinery manufacturers Vipeak Machinery Co., Ltd

Situated in High and New Technical Industry Development Area, Zhenghzou, China, Zhengzhou Mining machinery manufacturers Vipeak Machinery Co., Ltd. is a high-tech company , cooperating with Sveadaka Company to develop and produce industrial mills.

     Current Position  News Center -- Means to Solve the Ball Mill Tile Oil Leakage Problem
Product List
  Mill Machine
HGM Series Micropowder Grinder
Raymond Mill
Straight Centrifugal Grinder
High Pressure Suspension Grinder
High Pressure Micro-powder Grinder
Ball Mill
  Crushing
Jaw Crusher
Impact crusher
PY Series Spring Cone Crusher
Hydraulic Cone Crusher
Symons cone crusher
Hammer crusher
   Production Line
Stone Crushing & Screening Plants
Sand Making & Washing Plants
   Sand Making & Screening
Sand Making Machine
Sand Washing Machine
Circular Vibrating Screen
Belt Conveyer
Vibrating Feeder
  Beneficiation Equipment
Drying Machine
Condensing Machine
Spiral Separator
Magnetic Separator
Flotation Machine
Means to Solve the Ball Mill Tile Oil Leakage Problem

Zhengzhou Vipeak is a professional ball mill supplier, and it produces various ball mill products and analyzes the used ball mill problems for its customer. Zhengzhou Vipeak is not only a ball mill supplier in China, but also the solution scheme.


After the ball mill operates for some time, there is some spray orifice on the spray bar which is blocked by the impurities in the oil, at this time, the oil pressure in the spray orifice rises which leads to the other orifices unplugged increase in flow chart. The oil near the oil slinger will splash out of the oil slinger which leads to the oil leakage.


Solutions: dredge the blocked oil hole on the spray bar, and check the ball mill spray bar regularly and clean in time once the banked-up spearhead is found. Pay attention to that the clean the oil sprout hole by the soft texture tool to avoid the hardness material s damage to the oil sprout hole.


There is another reason for the ball mill oil leakage, that is when the opening of the ball mill front (rear) tile accelerator is relatively large, the oil sprout quantity will be increased. So the oil will drop from the orifice to the hollow shaft and then splash out of the oil slinger and leak out from the felt oil seal.


And the ball mill solution is that turning down the accelerator properly to decrease the sprout oil mass. When adjust the accelerator, it should be done by the experienced people.

As in case the accelerator is turned down undersize, the lubricant oil quantity of the bearing will be insufficient and the friction force will be increased which makes the main bearing set temperature rises. Once the phenomenon can t be dealt with, the main bearing will be burnt up.


As a ball mill and jaw crusher supplier in China, Zhengzhou Vipeak is trustworthy and has gained good word of mouth. All the ball mill customers can be assured of the ball mill products quality. Look forward to cooperate with you.

   Mill Series   |   Crusher Series   |   Mine Selection Machine   |   Fittings
Add: National High& New technical Industry Development Zone, zhengzhou, China     Postcode: 450007
International Trade Department Tel0086-371-67771005 0086-371-67770980     Fax0086-371-67775288
Emailvipeak111@yahoo.com     MSN violabb@hotmail.com